Spigen Tesla Screen TapLock Qi2 15W Wireless Charger Mount

Mount and charge a compatible magnetic phone beside the center display in a supported Tesla with the Spigen TapLock Qi2 wireless charger mount. The adhesive-free screen attachment supports charging up to 15W, while a rotating swing arm locks at 45-degree intervals for portrait or landscape viewing. A long L-shaped USB-C cable routes toward Tesla rear power outlets without turning the mount into a battery or power adapter.

Key Features

• Qi2 charging up to 15W: supports compatible phones, cases, cable routing, and vehicle power conditions.
• Adhesive-free TapLock mount: attaches to the compatible Tesla display edge without a permanent adhesive pad.
• Rotating swing arm: turns through 360 degrees and locks at 45-degree positions for different viewing angles.
• Magnetic alignment: holds MagSafe iPhones, PixelSnap phones, and supported Galaxy devices using an aligned magnetic case.
• L-shaped USB-C cable: provides a routed cable intended to reach the Tesla rear outlet arrangement.
• Screen-side placement: keeps navigation or charging status visible without using an air vent or dashboard suction base.

Charging and viewing beside the Tesla display

This mount is best for drivers of supported Model 3, Model Y, Model S, or Model X cabins who want the phone beside the center screen rather than on an air vent. The locking arm can position the phone vertically for messages and navigation or horizontally for compatible viewing. Install it where it does not block the Tesla display, driver sight lines, controls, airbags, or required sensors.

Compatibility depends on the screen edge, any installed screen protector, cabin revision, and other accessories. Some glass screen protectors can prevent a secure TapLock fit. Follow the installation sequence carefully to avoid bubbles or pressure on the protector. This mount is not compatible with the Spigen under-screen storage accessory for Cybertruck, and Cybertruck is outside this product's vehicle fit.

Charging speed depends on the phone, case, power source, cable connection, battery state, alignment, and temperature. Android phones generally need a suitable MagSafe-compatible or PixelSnap case unless the device already provides the correct magnetic system. Thick wallet cases, metal plates, loose rings, or misaligned cases can weaken attachment and interrupt charging.

Compatibility

vehicle fit includes compatible Tesla Model 3, Model Y, Model S, and Model X center displays, including the stated 2025/2026 Model Y Juniper setup. Phone support includes MagSafe iPhone 12 through iPhone 17 families, Pixel 10 PixelSnap models, and selected Galaxy phones with a correctly aligned magnetic case. It is not designed for Cybertruck or non-Tesla screens.

Package Includes

• 1 × Spigen TapLock Qi2 wireless charger mount
• 1 × long L-shaped USB-C charging cable
• Color: Black
• Vehicle power adapter not included unless separately stated

FAQ

• Who is this charger mount best for?
  It suits supported Tesla Model 3, Y, S, or X drivers who want magnetic phone charging beside the center display.
• Will it fit with every screen protector?
  No. Some glass protectors can interfere with TapLock installation; confirm protector thickness and follow the installation steps.
• Does every phone receive 15W?
  No. Up to 15W depends on Qi2 support, case, alignment, cable, vehicle power, temperature, and battery conditions.
• Can I use it in a Cybertruck?
  No. Cybertruck is outside the stated fit, and the mount conflicts with the specified under-screen storage accessory.
• Do Galaxy phones need a magnetic case?
  Usually yes. Use a correctly aligned MagSafe-compatible case unless the phone already includes a suitable magnetic attachment system.